Answer:
a. facilitate improvements but do not necessarily cause them.
Explanation:
Decision Support Systems are interactive Information systems that assist decision makers in coming up with strategies that help the organisation achieve its goals .The model base of the DSS uses mathematical and statistical models to analyse information then it generates reports and suggest possible solutions that can be implemented .The system is capable of giving a specific solution and some even allow the decision makers to give input before suggesting the most applicable solution.The effectiveness of a DSS is equally as important as its efficiency .The DSS unlike the conventional decision-making process should be able to analyse information effectively and come up with solutions in the shortest possible time frame.
A network administrator notices that some newly installed Ethernet cabling is carrying corrupt and distorted data signals. The new cabling was installed in the ceiling close to fluorescent lights and electrical equipment
Two factors may interfere with the copper cabling and result in signal distortion and data corruption are :
EMI
RFI
Explanation:
- EMI (electromagnetic interference) is the disruption of operation of an electronic device when it is in the vicinity of an electromagnetic field (EM field) in the radio frequency (RF) spectrum that is caused by another electronic device.
- During EMC testing, radiated emissions measurements are made using a spectrum analyzer and or an EMI receiver and a suitable measuring antenna.
- EMI (Electromagnetic Interference) is also called RFI (Radio Frequency Interference).
- Conducted RFI is unwanted high frequencies that ride on the AC wave form. Radiated RFI is emitted through the air. There are many pieces of equipment that can generate RFI, variable frequency drives included.
- The internal circuits of personal computers generate EM fields in the RF range.
Explanation:
We can divide the multiplex in different categorize, for example:
- FREQUENCY DIVISION MULTIPLEXERS (FDM)
-
TIME DIVISION MULTIPLEXERS (TDM)
-
STATISTICAL TIME DIVISION MULTIPLEXERS (STDM).
But in this case, we're going to explain about the time and frequency, because the time division multiplex differ to frequency, because the circuit is divided horizontally, and the time is vertically
b. splits the communication circuit vertically (with time slots) instead of horizontally
Answer:
b. typically contain more circuits in the network than in star or ring networks
Explanation:
In mesh architecture, all computers are connected to each other. In mesh all nodes connect directly and non hierarchical to each other so as to efficiently route data.
Mesh combines the benefits of both ring and star networks. It usually provide relatively short routes through the network (compared to ring networks) and provide many possible routes through the network to prevent one circuit from becoming overloaded (as compared to star network). Mesh network uses decentralized routing with each network performing its own routing.
Mesh network typically contain more circuits in the network than in star or ring networks and are more expensive than ring networks