Complete Question:
The first electric, general-purpose computer, ENIAC, was programmed by?
Group of answer choices.
A. Calculating algorithms on paper.
B. Entering code directly into the computer.
C. Flipping switches by hand.
D. Using MS-DOS as the operating system.
Answer:
C. Flipping switches by hand.
Explanation:
The first electric, general-purpose computer, ENIAC, was programmed by flipping switches by hand.
ENIAC is an acronym for Electronic Numerical Integrator and Computer, it was developed in 1945 by John Mauchly and J. Presber Eckert. ENIAC was used for solving numerical problems or calculation-related tasks by the process of reprogramming.
In order to give the ENIAC a series of machine instructions to follow in the execution of a task, the programmers had to undergo the cumbersome procedure of connecting, removing, reconnecting cables and flipping switches by hand because data couldn't be stored in memory.
Answer:
DDR3 SDRAM having twice rate of data transferring as compared to DDR2 SDRAM both have 240 pin connection. DDR3 memory power consumption is 40 % less as compared to DDR2. both are transfers data on a 64 data bits wide bus. The physical difference occur in both type a cut is present at bottom along pin in DDR2 it is occur probably in center and In DDR3 it is occur at left through center.
Line 4
It should be font-size: 15px
Also there should be curly braces in line 5.
Answer:
I believe it would be button and tool bar
