Answer:
DNS stand for the domain name system and it is used to convert the IP address into the readable system. It basically used to store the data and link with the domain name and the IP address when it is requested.
DNS are important because there is no requirement of memorizing the IP address of huge number of websites and host computer. We only need to remember the domain name of that particular website as it save the IP address of all the particular websites.
In network architecture, the domain name system is very essential and important part.
The
nmap.org website
Nmap is an open source utility for security auditing and network
discovery. Many network admins also use it for networks inventory and
monitoring host or service uptime. It uses raw IP packets in novel ways to
determine what hosts are available on the network.
Answer:
CSS is easy
Explanation:
CSS is like the color or your sylte for a webpage.
Answer:
//variable integer_list to hold a list of integers
DECLARE integer_list
ASSIGN values to integer_list
//variable sum to hold the sum of the elements in the list
DECLARE sum
ASSIGN zero to sum
//loop through the integer_list and sum all it's elements together.
for(int i=0; i<integer_list.size(); i++){
sum += interger_list.get(i)
}
//Show the result of the addition from the for loop
DISPLAY "The sum is " + sum
Explanation:
The above code uses some hypothetical programming language syntax. The second and third lines declare an arbitrary integer list and assign a set of values to it respectively.
The fifth line declares a variable "sum" which will hold the result of summing all the elements in the list. The sixth line initializes "sum" to zero.
The for loop shown iterates through the integer list cumulatively summing its elements.
The result is displayed as written on line 12.
Hope it helps!
Answer:
val > max
Explanation:
Assuming the values array is already created, inside the loop, we need to check if the val, a value in the values array, is greater than max. If it is greater than the max, that means it is our new max. Then we would set the max as the val. This way, if there is any value greater than max, it will be our max at the end of the loop.
