N x 100 = n%
An example:
<span>12 is 20% of 60. In order to get 12 percent of 60, all you need to do is to divide 12 with 60. To get the percent means to get the parts of 100. To get it in the form of percent, just multiply the quotient by 100. 12/60=.2 x 100 = 20% .</span>
The steps to use to construct a frequency distribution table using sturge’s approximation is as below.
<h3>How to construct a frequency distribution table?</h3>
The steps to construct a frequency distribution table using Sturge's approximation are as follows;
Step 1: Find the range of the data: This is simply finding the difference between the largest and the smallest values.
Step 2; Take a decision on the approximate number of classes in which the given data are to be grouped. The formula for this is;
K = 1 + 3.322logN
where;
K= Number of classes
logN = Logarithm of the total number of observations.
Step 3; Determine the approximate class interval size: This is obtained by dividing the range of data by the number of classes and is denoted by h class interval size
Step 4; Locate the starting point: The lower class limit should take care of the smallest value in the raw data.
Step 5; Identify the remaining class boundaries: When you have gotten the lowest class boundary, then you can add the class interval size to the lower class boundary to get the upper class boundary.
Step 6; Distribute the data into respective classes:
Read more about frequency distribution table at; brainly.com/question/27820465
#SPJ1
Answer:
D
Step-by-step explanation:
Parallel lines have the same gradient.
A line with a slope of zero is a horizontal line. Although two lines that have a slope of zero will result in two parallel lines, not all parallel lines are horizontal lines. Since the question is asking for which statement <u>must</u> be true, option A is incorrect.
If the slopes of two lines are negative reciprocals, they are perpendicular to each other. This is because the product of the gradients of 2 perpendicular lines is -1. Let the gradient of the first line be A and the other be B.
AB= -1


Thus, option B is incorrect too.
Undefined slopes gives vertical lines. Like option A, if two lines have an undefined slope, they will be parallel to each other. However since parallel lines are nit necessarily vertical lines, option C is also incorrect.
Given that the cubical piece has side (s) 7 mm, and a cylindrical hole of diameter (d) as 3 mm.
The volume of the piece can be calculated as,

It is mentioned that the material costs $207 per cubic meter, so the cost (c) of 1 piece is calculated as,

This is the cost (in dollars) for 1 piece.
Given that the manufacturer wants to produce 1,000,000 such pieces, so the total cost (TC) is calculated as,

Thus, the total prototypes will cost around $60.75