Answer:
The answer to this question is given below in the explanation section.
Explanation:
The correct answer to this question is A: counter module.
Counter module in python or Python counter is a container that holds the count of each of the elements present in the container. It is a sub-class available in the dictionary class. Jamal can use this module in Python to write a program that will find the 10 most common words in Romeo and Juliet.
Other options are not correct because:
While loop: while loop only iterates its body until a specific condition is met. For loop is used to iterate to a pre-specified condition and iterate until the condition is reached. While the mean module of Python is used to calculate mean and average.
Answer:
NTSC, Timecode
Explanation:
NTSC was used for television broadcasting in the USA, and some other countries. And it archives a video signal that exceptionally deciphers every frame of the tape with the assistance of the time stamp in unit time and frames. We have other options as well, which are PAL and SECAM. However, now and since 2013, these are being converted into the digital. The frame rate of the NTSC in the US was 29.97 fps. And this defines how good video you are going to receive.
And timecode is the signal that is recorded with the video that can quite exclusively figure out each frame of the tape with the help of the time stamp in unit time and frames.
Answer:
Analyze network traffic
Identify the method of execution
Explanation:
Threat Hunting is a form of cybersecurity strategy carefully formulated to recognize threats that are yet to be found by routine security monitoring.
Using the approach of Threat hunting means applying unconventional techniques to determine the threats or find the origin of the malware.
Hence, in this case, the system engineer should carry out the following steps:
1. Analyze network traffic
2. Identify the method of execution
Answer:
Bootrec.exe
Explanation:
The process of turning on a computer system is called booting. When a computer system boots, it runs the post test and loads into memory, the information or program needed to run the operating system, and then locates the operating system from the boot manager record in the disk partitions. When the disk is failed to be recorded, or the boot manager or sector is corrupt or lost, the bootrec.exe command is used in the command prompt to correct these problems.
