The answer to this question would be to be in a boat on a lake.
There are two kinds of waves during an earthquake, the P-waves and the S-waves. The P-waves or the Primary wave would be the fastest seismic wave between the two and literally would be the first one to arrive during an earthquake. The S-waves or the Secondary waves would be the next waves that arrive after the P-waves have passed. The difference between the two is that the Primary waves pass through all solid and liquid surfaces while the Secondary waves pass through only solid surfaces and not liquid surfaces. When you are in a concrete shelter underground, you would still be affected by the S-wave. The same goes when you are in a cement basement. When in a very tall building, you would feel it much more since the altitude gives more shake to the building unless the building is built to withstand earthquakes. Being in a boat on a lake would make you avoid the S-wave but not the P-wave.
Answer:
B- the flooding of low-lying coastal areas
Explanation:
just did the test on edge
Bacteria attacks the immune system, taking over the immune system cells, turning them to bacteria. Essentially making the immune system cells attack each other and multiplying.
Answer:
•B. a form of energy is required to be input so it can become orderly again
Explanation:
Order can be restored from a disordered system by inputing energy. The energy helps restore back the orderliness in a system.
We know that entropy is the state of randomness or disorderliness of the particles of a system. Entropy increases with rise in temperature. When the heat energy that causes temperature rise is removed from a system, the kinetic energy require for molecules to move is reduced and orderliness can gradually be approached.
For example, heating of water causes agitation of its molecules. The randomness of it particles increases. This is seen in the phase change from liquid to gases. As temperature is lowered, the water cools and orderliness is approached again. We can approach more orderliness by putting the water in a refrigerator.
In some systems, we can bring gases into a more ordered state by compression. The pressure applied to compress gases is a form of energy because work is done to bring the molecules into close contact as seen in a gas cylinder.
