Answer:
About 110.6
Step-by-step explanation:
The sine of an angle is the length of the opposite side divided by the length of the hypotenuse.
Hope this helps!
Which One Doesn't Belong?
2 answers:
You might be interested in
Answer:
Step-by-step explanation:
From the given information, the symmetric equations for the line pass through(4, -5, 2) i.e () and are parallel to
The parallel vector to the line i + zj+k = ai + bj + ck
Hence, the equation for the line is :
x = 4 + t
y = -5 + 2t
z = 2 + t
Thus, x, y, z = ( 4+t, -5+2t, 2+t )
The symmetric equation can now be as follows:
∴
Answer:
see below
Step-by-step explanation:
A protractor is usually a transparent measuring device laid intended to be laid over an angle to be measured. The centerpoint of the protractor's scale is made to coincide with the angle's vertex, and the baseline of the protractor is aligned with one of the angle's rays. The appropriate scale is used to read the angle where the other ray crosses the scale. You usually have to visually determine if the angle is acute or obtuse, so you can choose the correct scale to read.
__
If you're drawing an angle, first draw one ray and locate the vertex on it. Then do the steps above as you would for measurement. Make a mark on your paper corresponding to the desired angle measure, and connect the vertex to that mark to create the other ray of the angle.
__
If you're working with a printed protractor, you may need to do your work on a piece of translucent paper or transparency material, so you can see the protractor scale through the page you're drawing on.
_____
<em>Comment on a printed protractor</em>
A protractor will only give accurate measurements if its geometry is perfect. Some printers will scale a figure differently in horizontal and vertical directions, so will make the protractor scale be elliptical instead of circular. That will give wrong readings.
