Answer:
C
Step-by-step explanation:
If you have a Ti-84 series calculator, press "stat" then "Edit..." and then fill in the data table values for x and y in two lists. Then press "2nd" and "mode" to quit. Now press "stat" again and right arrow over to "calc" and press down until you find "ExpReg" and set the "Xlist" and "Ylist" that you used and you will get C as the answer. Another way to do this is to manually substitute values into all 4 equations, which is boring.
Answer:
56.25 pi cm^2
Step-by-step explanation:
To find the area of the circle,
we use the formula
A = pi r^2, where r is the radius
We know the diameter is 15 so we can find the radius from
r = d/2 where d is the diameter
r = 15/2
A = pi ( 15/2) ^2
A = pi ( 225/4)
A = 56.25 pi cm^2
Answer:
see below
Step-by-step explanation:
Every vertex moves twice as far from the center of dilation as it is in the pre-image.
Perhaps the easiest image point to find is the one at lower left. In the pre-image it is 2 units left of the center of dilation, so the image point will be 2×2 = 4 units left of the center of dilation. It will be located at (-6, -2).
Other points on the image can be found either by reference to the center of dilation, or by reference to known image points. For example, the next point clockwise is 1 left and 4 up in the pre-image, so will be 2 left and 8 up from (-6, -2) in the image. That is, the pre-image point (-5, 2) becomes image point (-8, 6). You will note that (-5, 2) is 3 left and 4 up from the center of dilation, and that (-8, 6) is 6 left and 8 up from the center of dilation (twice as far away).
No. It would be a arithmetic sequence