Answer:
#include <stdio.h>
int main() {
const int NUM_VALS = 4;
int origList[NUM_VALS];
int offsetAmount[NUM_VALS];
int i;
origList[0] = 40;
origList[1] = 50;
origList[2] = 60;
origList[3] = 70;
offsetAmount[0] = 4;
offsetAmount[1] = 6;
offsetAmount[2] = 2;
offsetAmount[3] = 8;
for (i = 0; i < NUM_VALS; ++i) {
printf("%d ", origList[i] - offsetAmount[i]);
}
printf("\n");
return 0;
}
Explanation:
- After writing all the code given in the question, run a for loop until the variable i is less than the value of NUM_VALS constant.
- In other words, the for loop will be executed 4 times as the value of NUM_VALS constant is equal to 4.
- Inside the for loop display the results by subtracting offsetAmount from origList.
Answer:
Fixed configuration switches contain a fixed number of ports and cannot be expanded.
Installing a single 48- port fixed-configuration switch is better in two ways. First, the switch contains 48 ports which are more than the other fixed configuration switch containing 24 ports so there is an availability of more ports for source and destination devices. Port is basically an interface between computer and other end devices. Its advantage is that more devices can interact or connect this way, with less packet collision, hence enhancing network performance.
Secondly rather than setting up two switches, which will take space and consume more power, its is a better way is to have one switch installed. It does not require much space. A single 48-port fixed-configuration switch will have less space and power requirements as compared to two 24-port fixed-configuration switches which is more suitable for supporting two classrooms.
A computer network is a set of computers that share resources and includes nodes. Maria is using a router to receive, send and identify data. Thus, option B is correct.
<h3>What is a router?</h3>
A router is a device for networking that shares the networking data to the designated IP addresses and uses the same connection. The data are transmitted via the Internet.
The data that is sent, identified, and received is in the form of the data packets and are transmitted through the subnetworks. A repeater in a computer network amplifies the received signals.
Therefore, option b. the router is the correct option.
Learn more about routers here:
brainly.com/question/18322527
#SPJ1
Loading test data in place of user input for Flows is invalid for execution by unit Tests.
<h3><u>
Explanation:</u></h3>
A test that examines a specific part of a code and its functionality refers to the unit test. It is helpful in the examination of the functions of a certain piece of code and check the behavior. The pieces of the code that is covered for the examination by a unit test is called as the test coverage.
It only examines a part of a code and not a code as a whole. In the scenarios given in the question, the scenario of Loading test data in place of user input for Flows will be invalid for the unit test execution. This is because when an user gives an input then the entire code will be executed for getting the result which is not covered by an unit test.