<span>B. Efficiency
(</span><span>effective training </span><span>techniques)</span>
Answer:
a. Remove the affected servers from the network.
Explanation:
An organization's incident response process (IRP) can be defined as all of the process involved in the cleanup and recovery of data when they fall victim to an attack or cybersecurity breach. The incident response process comprises of six (6) important stages and these are;
1. Preparation.
2. Detection and analysis (identification).
3. Containment.
4. Eradication.
5. Recovery.
6. Review of incident activities.
When an organization's IRP prioritizes containment over eradication and an incident is discovered, where an attacker outside the organization installed a crypto-currency mining software on the organization's web servers. Given the organization's stated priorities, the cybersecurity engineer should remove the affected servers from the network.
A containment process is focused on taking steps to eliminate or contain the attack. It basically involves acting swiftly in response to the attack, so as to prevent it from spreading across board or in order to mitigate the damage already caused.
In this context, the cybersecurity engineer should remove the affected servers from the network in accordance with the organization's IRP priority (containment).
<em>Furthermore, he could take a step further to contain the attack by installing a firewall and updating their policies in the Intrusion Prevention System (IPS) of the organization. </em>
Answer:
c.
Explanation:
People trust open-source software - if they can see how it works and understand it, they can help improve it and build applications using it. If these protocols were not publicly available - then nobody would have implemented services using them - so nobody would be adopting it.
Answer:
B)tracert
Explanation:
Tracery Command can be regarded as
network diagnostic tool, it is used in tracking process of pathway of packet ranging from source to destination on IP network. It as well allows to know real time of each hops that are been taken by a packet as it enroutes to it's destination. The traceroute can be run by following these steps:
✓Open the run window
✓Open Command prompt, this can be done by enter "cmd" then enter.
✓ input" tracert" then destination ( Ip address or web address)
It should be noted that Tracery command issued from the command prompt will show the route that a packet travels from the issuing computer to another computer.
