Answer:
# create the file
filename = "Testfile.txt"
# for writing, we create the output file:
outPutfile = open(filename, "w")
# Writing numbers from 1-100
for item in range(1,101):
outPutfile.write((str)(item))
outPutfile.close()
# printing the contents to verify it worked correctly
infile = open(filename, "r") #note the "r" indicates the mode
fileContents = infile.read()
infile.close()
print(fileContents)
Explanation:
- Define the working file fileName = TestFile
- Create the output file for writting outPutfile = open(filename, "w")
- Use a for loop to write numbers from 1-100 to the file outPutfile.write((str)(item))
- Close the file outPutfile.close()
- You may open the file read its content and print the contents to verify it worked correctly
The UAC is on by default. So, you don't need to turn it on unless someone else turned it off.
The UAC has four modes.
The lowest mode is the off position. If the UAC is off, no UAC prompt will pop up when doing administrative tasks.
If a router tried to match a packet sourced from IP address 1.1.1.1 using this ACL, the first statement will be used.
a. First
<u>Explanation:</u>
We use ACL technology to make basic security level in the network. ACL is strictly used to update the routing in the network and make sure network pears and make sure the flow control for network traffic is followed.
Since it is routing ip address through ACL statement. It all depends on how the network engineer routed the traffic in the network. A packet with source IP address 1.1.1.1 would match any of the three explicitly configured commands described in the question. As a result, the first statement will be used.
The router searches the ACL statement by order and when the match is found it stops execution of the ACL statement that will match with the first occurrence.
Depends, but I'd say false.
Answer:
Second Generation: transistors
Third Generation: integrated circuits
First Generation: vacuum tubes
Explanation:
Generations of computers are categorized based on the technologies that were used in them.
Given innovations or technologies are:
<u>transistors
:</u>
Transistors were introduced in the second generation in place of vacuum tubes.
<u>integrated circuits
:</u>
Integrated circuits were introduced in the third generation. An IC consists of multiple transistors.
<u>vacuum tubes:</u>
The very first generation of computers used vacuum tubes to do the calculations. the only drawback was that the tubes used to heat up very soon.
Hence,
Second Generation: transistors
Third Generation: integrated circuits
First Generation: vacuum tubes
