Answer:
The answer to this question is given below in the explanation section.
Explanation:
The CPU is responsible for processing instruction. CPU instruction processing goes through three stages. Fetch, Decode, and Execute.
When the program runs, program code is copied from secondary storage into main memory. CPU's program counter set to the first instruction of the program stored in memory where the program starts executing.
When a program is being executed, it goes through fetch-decode-cycle. which repeats over and over again until reaching the STOP instruction.
The processor check which next instruction to be executed, then the processor fetches that instruction value from the memory location. once the instruction being fetched it gets decoded and executed. This instruction processing cycle repeating until the CPU finds a stop instruction.
Answer:
1111000
Explanation:
perform the following. write from right to left:
- is the number even? then write down a 0
- is the number odd? then write down a 1 and subtract 1
- divide by 2
- repeat until you reach 0.
So for 120:
120 is even, so write down a 0 and continue with 120/2=60
60 is even, so write down a 0 and continue with 60/2=30
30 is even, so write down a 0 and continue with 30/2=15
15 is odd, so write down a 1 and continue with 14/2=7
7 is odd, so write down a 1 and continue with 6/2=3
3 is odd, so write down a 1 and continue with 2/2=1
1 is odd, so write down a 1 and finish with 0
The answer most likely B NOT SURE )
D)It did not change the curriculum because Scopes lost the case.
Answer:
DECLARE SUB SQUARE (N)
CLS
INPUT “ENTER ANY NUMBER”; N
CALL SQUARE(N)
END
SUB SQUARE (N)
S = N ^ 2
PRINT “SQUARE OF NUMBER “; S
END SUB