Answer:70
Explanation:
It is important to remember that a protractor is a measuring instrument that is used to measure angles in degrees. Then, in order to measure an angle in degrees using a protractor, you can follow these steps:
1. You must place the center point of the protractor on the vertex of the angle.
2. Then, you must line up the baseline of the protractor with one side of the angle.
3. Finally, you can read the angle in degrees. In this case, you can observe in the image attached that the protractor is placed on the vertex "H" of the angle JHG. Therefore, based on the explanation shown before, you can identify that the measure in degrees of the angle JHG is the following: m\angle JHG=70\°
There is a device called a thermometer for that...
Answer: Options (1), (3), (4), (6) and (9)
Explanation: Hot-spots are the region of active volcanisms and this could be due to the presence of large mantle plumes, plate tectonic movement, as well as other reasons.
Hot-spots are generated in the following tectonically active boundaries such as-
- Convergence of two oceanic plates.
- Convergence of an oceanic and continental plate.
- Divergence of two oceanic plates.
- Hotspots within the oceanic and continental plate.
Based on the metamorphic rock at Van Hise Rock, Rock Springs, the protoliths will become quartzite and phyllite.
<h3>What rocks will the protoliths form?</h3>
The Sandstone(Quartz) will go through processes and eventually deform into the rock known as quartzite.
Shale will go through similar degradation processes to become the rock, phyllite.
Find out more on protoliths at brainly.com/question/13496997.
#SPJ1
