Answer:
Question is incomplete. it needs a topology diagram and also it needs Router R1 table. I assume User has access to the topology and Routing table.
Below Configuration will help to fix ACL problem
Hosts from the 172.16.0.0/16 network should have full access to Server1, Server2 and Server3 but this is not currently the case, as L1 can’t communicate to Server2 or Server3.
Explanation:
Following Configuration on Cisco Router R1 will help to fix all the ACL problems.
enable
configure terminal
no ip access-list standard FROM_10
ip access-list standard FROM_10
deny host 10.0.0.2
permit any
exit
!
no ip access-list standard FROM_172
ip access-list standard FROM_172
permit host 172.16.0.2
exit
!
interface GigabitEthernet0/0
ip access-group FROM_192 out
end
write memory
!
Answer:
abbreviation for technical or technological
Http://www.webopedia.com/DidYouKnow/Hardware_Software/FiveGenerations.asp
Answer:
You entered number two
Explanation:
Because even though it is greater than 0, it already has a set function in place.