The resistance of a given object depends primarily on two factors: What material it is made of, and its shape. For a given material, the resistance is inversely proportional to the cross-sectional area; for example, a thick copper wire has lower resistance than an otherwise-identical thin copper wire. Also, for a given material, the resistance is proportional to the length; for example, a long copper wire has higher resistance than an otherwise-identical short copper wire. The resistance R and conductance G of a conductor of uniform cross section, therefore, can be computed as
<span />
where is the length of the conductor, measured in metres [m], A is the cross-sectional area of the conductor measured in square metres [m²], σ (sigma) is the electrical conductivity measured in siemens per meter (S·m−1), and ρ (rho) is the electrical resistivity (also called specific electrical resistance) of the material, measured in ohm-metres (Ω·m). The resistivity and conductivity are proportionality constants, and therefore depend only on the material the wire is made of, not the geometry of the wire. Resistivity and conductivity are reciprocals: . Resistivity is a measure of the material's ability to oppose electric current.
This formula is not exact, as it assumes the current density is totally uniform in the conductor, which is not always true in practical situations. However, this formula still provides a good approximation for long thin conductors such as wires.
Another situation for which this formula is not exact is with alternating current (AC), because the skin effect inhibits current flow near the center of the conductor. For this reason, the geometrical cross-section is different from the effective cross-section in which current actually flows, so resistance is higher than expected. Similarly, if two conductors near each other carry AC current, their resistances increase due to the proximity effect. At commercial power frequency, these effects are significant for large conductors carrying large currents, such as busbars in an electrical substation,[3] or large power cables carrying more than a few hundred amperes.
She is in the perimenopausal phase of menopause.
Answer:
B
Explanation:
Answer is not A because this is not a benefit
Not C because it is also not a benefit
not D because it is not a benefit
B is the only benefit listed.
Answer:
a. all tall
Explanation:
If genotypically one of the parents is homozygous dominant and another one is heterozygous for plant height then phenotypically all their progeny will be tall.
Let us suppose, 'T' represents dominant allele and 't' represents recessive allele. Then the genotype of one parent who is homozygous dominant will be TT and genotype of another parent who is heterozygous will be Tt.
The cross is depicted in the attachment.
Here it may also be noted that genotypically two of the progeny will be homozygous dominant while two of the progeny will be heterozygous but phenotypically all the progeny will be 'tall'.
According to Wikipedia the answer is, "Wound healing. Wound healing is a complex process in which the skin, and the tissues under it, repair themselves after injury. ... This process is divided into predictable phases: blood clotting (hemostasis), inflammation, tissue growth (proliferation), and tissue remodeling (maturation)."
