The simplified equation is given as Y=A_3A0+A3A0. To draw the circuit diagram using a minimum number of gates we use this equation and the x^2 equation to form the truth table. This is further explained below.
<h3>What is a circuit?</h3>
Generally, a circuit is simply defined as a full circular channel via which electricity travels in electronics. A power flow, terminals, and a drain make up a basic circuit.
In conclusion, The circuit will need 4 inputs to produce 16 combinations in order to determine if the month contains 31 days. At 4 inputs, there are 12 inputs required. the
Hence,we use this information and the x^2 equation to form the truth table
the Equation is given as
Y=A_3A0+A3A0
Read more about circuit
brainly.com/question/27206933
#SPJ1
Answer:
RADIUS
Explanation:
Remote Authentication Dial-In User Service (RADIUS) is a networking protocol that provides centralized Authentication, Authorization, and Accounting management for users connected to a network service. It can be used to authenticate anyone who is on your network.
RADIUS is a protocol that uses TCP or UDP as transport. RADIUS client is what is used to communicate with RADIUS servers at gateways of the network.
Answer:
A. 0
Explanation:
The technician should configure the RAID 0 for Joe.
RAID 0 also referred to as the striped volume or stripe set is configured to allow the fastest speed and the most storage capacity by splitting data evenly across multiple (at least two) disks, without redundancy and parity information.
Also, RAID 0 isn't fault tolerant, as failure of one drive will cause the entire array to fail thereby causing total data loss.
Answer:
1. The network address for 172.22.49.252/17 is 172.22.0.0/17.
2. The last valid assignable host address of 172.22.4.129/26 is 172.22.4.190.
3. The first and last host address of 192.167.25.25/16 is 192.167.0.1 and 192.167.255.254.
4. The broadcast address of 10.75.96.0/20 is 10.75.111.255
Explanation:
Subnetting in networking is the process of managing the use of host addresses and subnet masks of a network IP address. For example, the IP address "172.22.49.252/17" is a class B address that receives an extra bit from the third octet which changes its subnet-mask from "255.255.0.0" to "255.255.128.0". with this, only 32766 IP addresses are used, with the network address of "172.22.0.0/17".
Answer:
It prints "hi" only one time.
Explanation:
It will print the result depending on the if statements. If you look at the if statements, you will see that no matter you enter it is going to be either true for the first if statement or for the second if statement.
Let's say you entered 1 for x and 0 for y, first if statement will print hi, but the second one will not print because x is not smaller or greater than 0.
Let's say you entered 0 for x and 6 for y, second if statement will print hi, but the first one will not print because x is not greater than 0.