Answer:
50
var X gets passed into the rectangle function, which I assume would set the x and y coordinates to what the var's have already been set to.
Answer:
Following are the code to this question:
list_val = input()#defining a integer variable for input value
test_grades = list(map(int, list_val.split()))#defining test_grades as a list
sum_extra = -999 #defining sum_extra that holds negative integer value
sum_extra = 0#defining sum_extra that holds value
for y in range(len(test_grades)):#defining a for loop to check range of list
if(test_grades[y] > 100):# defining if block that check list value is greater then 100
sum_extra = sum_extra + (test_grades[y] - 100)#use sum_extra variable to hold extra value and add this value
print('Sum extra:', sum_extra)#print value
Output:
101 83 107 90
Sum extra: 8
Explanation:
In the above code a, "list_val" variable is declared, that uses an input method to input the values and declared a "test_grades" variable that uses a list method to add all values in the list.
In the next step, the "sum_extra" variable is declared, which holds some values and defines a for loop to check the range of the "test_grades", and define a if block, that checks list value is greater than 100. If the condition is true, it will remove the extra value, and add it into the sum_extera variable and add its value, and at the last use, print variable to print its value.
1. Requirements gathering/analysis.
2. Design.
3. Development.
4. Testing.
5. Maintenance.
Answer:
it is complex
employees are not involved
Answer:
The answer is "Option A".
Explanation:
In the given question the option A is correct, because the cost of defects increases the over all cost of the project. In the SDLC there are 7 phases in which the testing stage is used to improves the accessibility for all stake holders in the development process of project planning, and other options are not correct, because defects increases the cost not Decreases.
