Answer:
Explanation:
One group of students did an experiment to study the movement of ocean water. The steps of the experiment are listed below.
Fill a rectangular baking glass dish with water.
Place a plastic bag with ice in the water near the left edge of the dish.
Place a lighted lamp near the left edge of the dish so that its light falls directly on the plastic bag.
Put a few drops of ink in the water.
The student did not observe any circulation of ink in the water as expected because the experiment had a flaw. Which of these statements best describes the flaw in the experiment? (2 points)
Not enough ink was added.
Not enough water was taken.
The dish was too small for the experiment.
The lamp and the ice bag were at the same place.
"Special Files" are the device drivers that provide the interface to I/O hardware.
Answer:
The correct answer to the following question:
while sub < SIZE AND foundIt = "N"
Explanation:
Firstly, we start the pseudocode after that set the variable sub to 0 and size to 1 of num type and also set a num type array VALID_ITEM[5] and its elements are 27,53,84,89,95.
Than set string type variable foundIt to "N", then we set a while loop and correct its condition is "< SIZE AND foundIt = "N" ".
Than starts if condition which is "item = VALID_ITEM[sub]", if the condition is true than foundIt = "Y", after that endif.
Than increment the variable sub, after that endwhile, after this, we start if condition which is "foundIt = "Y" " if the condition is true then output "Valid item number" or else "Invalid item number", and then we endif and after all stop the pseudocode.
