The five steps in the fetch/execute cycle and how do they correspond to a restaurant

1 answer:

3 0

The five steps in the fetch/execute cycle are :
1) Instruction Fetch (IF) - This starts with the moving from the memory to
the control unit which is given by the program counter. The control unit
can then access the data immediately from the memory.
2) Instruction Decode (ID) - what task the system has to do, where the
results is to be stored and what operation is to be performed by which
data.
3) Data Fetch (DF) - it gets the value from the memory.
4) Instruction Execute (IE) - The particular instruction is executed.
5) Result Return (RR) - The Result Value is restored in a
particular memory location. The return of new data resulting from
(EX) that is put back into memory.

You might be interested in

again assume that each of the resistors in the circuit shown above has a resistance value of 100k(question in the picture above)

Svetllana [295]

Statement A is true. R4 is not part of the circuit since it has one terminal not connected. The other resistors are in series, so the same current flows through them. Hence they will dissipate equal power.

4 0

3 years ago

In most signal "timing diagrams" (like the one below) the signals do not change from low to high, or from high to low, abruptly.

melisa1 [442]

Explanation:

This transient state occurs due to the fact that the signal change from low to high and high to low doesn't occur intermediately but in a very small time, in relation to the signal time itself.

At transistor level there are parasitic (undesired) capacitances and resistances, formed due to the layout configuration of conductor and dielectrics. As consequence a RC circuit is formed, thus making a propagation delay.

This delay must be characterized for each circuit, and specified as tpHL (transition time from High to Low) and tpLH (transition time from Low to High)