Answer:
Explanation:
Talking about prototype model, we can say that, it is developed by knowing the requirments.
A client Interaction with prototype makes the client to have the ability to get the feel of system.
It is best for large systems as this helps to determine the requirements. It is not complete, this is because many of its details are yet to be built. Users also involved in its development.
Production system is a result of organizing inputs, then process is carried out and then output is based on some logic and functions. Production system fails if any such arrangement made don't give a desired level of outcome.
If requirments are missed then prodution system may fail. So prototype systems are not used as production systems.
If the d was large it would destroy e hole
Answer:
Yes, because the upper limit is less Than 8 minutes
Explanation:
According to the empirical formula :
68.26% of data lies within 1 standard deviation from the mean;
Hence,
Mean ± 1(standard deviation)
The sample mean and sample standard deviation of the given data is :
Sample mean, xbar = Σx / n = 546 / 100 = 5.46
Sample standard deviation, s = 2.475 (Calculator)
The interval which lies within 68.26% (1 standard deviation is) ;
Lower = (5.460 - 2.475) = 2.985
Upper = (5.460 + 2.475) = 7.935
(2.985 ; 7.935)
Since the interval falls within ; (2.985 ; 7.935) whose upper level is less than 8 means patients will have to wait less Than 8 minutes.
Answer:
Check the explanation
Explanation:
A packet filter firewall is used as a check point between internal corporate network to the outside internet. It blocks all the inbound traffic from the outside hosts trying to initiate a direct TCP connection to the internal corporate webserver. The network design with firewall is shown in the attached image below:
The figures in the attached image below shows an internal corporate network is protected with a packet filter firewall to minimize the inbound traffic from the external network or an internet. Therefore, the packet filter is used as a check point between the network.
The packet filter blocks all attempts by the outside hosts in order to initiate a direct TCP connection to the internal webserver of the internal corporate network.
Going by the second part of the attached image below can can therefore conclude that:
• Rule 1 specifies that, deny any packet with the destination address 5.6.7.8 if the STN flag of TCP header is set.
• Rule 2 specifies that, allow the inbound email traffic from the external source.
• Rule 3 specifies, allows the Outbound TCP traffic from the internal corporate network.
• Rule 4 specifies, allows outbound Email traffic from the internal corporate network to the external network.
• Rule 5 specifies, block any traffic from any source to the any destination.