Answer:
B) computeValue(10);
Explanation:
Given
Header: void computeValue(int value)
Required
Determine the valid call
To call a function from another function or from the main, the following syntax has to be used.
<em>function-name(parameter-1, parameter-2, parameter-3,.....,parameter-n);</em>
<em />
In the function header given:, the following can be observed:
- The function name is computeValue
- It has only one parameter and it is of type integer
So, to call the function; we make use of computeValue(10);
Where 10 represents the value of the parameter (i.e. argument)
Answer:
D. 4x as much
Explanation:
The answer is pretty simple. The question is asking about 10m/s and 20m/s right? Take a look at the energy at each point on the graph. At 10m/s the kinetic energy is 100 on the graph. At 20m/s the kinetic energy is 400. You'll notice that 100 x 4 is 400 - That's the answer.
You can also prove this mathematically. The formula for kinetic energy is

The question says: constant mass so we can ignore that for now.
(1/2) * 10^2 is (1/2) * 100 = 50
for the 20m/s ball it would be
(1/2) * 20^2 = 400 * 1/2 = 200
Once again, you see that it is 4x
The answer is B, look ahead and keep your eyes moving
Answer:
The definition of the issues is listed throughout the section down.
Explanation:
- Stranded cables are somewhat more compact and can be mounted quickly. Strong cables become rigid in design, and they are not versatile for installation. In comparison with solid connectors, amplification is indeed high.
- Unless the innermost layer including its wire is broken as we attempt to connect the cable, it will not function. So, whenever stripping the cables through the walls, it's indeed important not to rank the jack too profoundly.
- It would be quick to untwist the cable and then will ensure that perhaps the connection is appropriate for the most widely encountered rj-45 connection whenever the wiring of 0.5 inches becomes coupled up.
- If we don't keep the right pin colors in order, the relation won't work. Afterward, when another connexon is broken due to many complications, it would be impossible to figure out the contacts unless the pins coloring are not always in sequence.
- The connection pairs can be cut off through 0.5 inches within about therefore the gap within the connector is narrower and the wire would not be correctly attached if we break the cable further. The link is lost and the cable does not run properly.
- It is necessary to ensure that perhaps the wires are forced to the end of the platform since the connexon will indeed be broken as well as the connector would not operate unless the wires aren't moved. The wires will fall out of another socket as well.
- Before even being incorporated into another crimping unit, it is good to carefully check the connection sequence to ensure that perhaps the wires are to the end since it is impossible to verify the sequence until the wires are attached to something like the connector. Unless the connections are not always in alignment, the link will also not be provided and indeed the wire would not operate correctly, even if the link is provided. Such wires can also be presented to use load barriers, and that it's the simplest operation.
- The Durability Tester has been used to determine the hardness between two stages, whereas the connection efficiency is tested using the qualification tester.
Answer:
Alt + F9
Explanation:
The Keyboard shortcut that Stephen can use use to toggle between data and the field codes is Alt + F9. This is in regards to Microsoft Word Fields for both Windows and Mac operating systems. Although ALT + F9 will toggle between these two but for all the fields within the document. If you want to toggle between a single or various fields it would be Shift + F9.