<h2>Dead lock is possible in Bank Transactions</h2>
Explanation:
Let us understand the term "Dead lock"
A deadlock is a situation where whole set of process is locked, since each of the process is waiting or holding the resource of another process. Each process will be interdependent and waiting for the same resource.
Deadlock is possible during bank transaction in the following situation:
A & B are two accounts where A tries to transfer funds to B and B tries to transfer fund to A.
When both tries to transfer funds at the same time, deadlock occurs.
A deadlock can be avoided by any one of the four methods.
They are: Mutual exclusion, No preemption, circular wait, hold and wait.
Answer:
B) because it is hard to find cables that have the same standard.
Explanation:
Hope this helps!
Answer:
FULL neighbor state.
(FULL/DR or FULL/BDR)
Explanation:
The fact that the routers are neighbors is not enough to guarantee an exchange of link status updates; they must form adjacencies to exchange link status updates. Adjacency is the next step after the process of establishing neighbors. Adjacent routers are routers that go beyond a simple Greeting exchange and act in the database exchange process. To reduce the amount of information exchange in a given segment, OSPF selects a router as a designated router (DR) and a router as a designated backup router (BDR) in each multiple access segment. The BDR is chosen as the backup mechanism in case the DR fails. The idea behind this is that routers have a central point of contact for the exchange of information. In order to verify if two routers have established an adjacency, you can use the command: show ip ospf neighbor.
Here is an example:
R1#show ip ospf neighbor
Neighbor ID Pri State Dead Time Address Interface
203.250.12.1 1 2WAY/DROTHER 0:00:37 203.250.14.3 Ethernet0
203.250.15.1 1 FULL/DR 0:00:36 203.250.14.2 Ethernet0
203.250.13.41 1 FULL/BDR 0:00:34 203.250.14.1 Ethernet0
Answer:
1. The tools panel
2. The actions panel
Explanation:
The tools panel contains properties that allow for text and object creation. The actions panel contains properties that allow for the alignment and distribution of titles.
Under the tools panel, we can find properties like; line, arc, an arrow for selection, different shapes like rectangle and the clipped corner, vertical type, vertical area type, vertical path type, etc. Under the actions panel, properties like; align, center, and distribute can be found.
Answer:
intArray=array(’b’,[2,5,10])
Explanation:on edge
