Answer: A (-2, 3)
Step-by-step explanation:
1. To know which oredered pairs does not lie on the graph, you must substitute the x-coordinate of each one of thm into the function and if you obtain the y-coordinate shown in that ordered pair, then that point lies on the graph.
2. Therefore, you have:
A. x=-2
(It does not lie on the graph).
B. x=--1
(It lies on the graph).
C. x=3
(It lies on the graph).
D. x=4
(It lies on the graph).
Therefore, the answer is the option A.
Answer:
The Great Ocean Conveyor Belt
Step-by-step explanation:
The ocean is not a still body of water. There is constant motion in the ocean in the form of a global ocean conveyor belt. This motion is caused by a combination of thermohaline currents (thermo = temperature; haline = salinity) in the deep ocean and wind-driven currents on the surface. Cold, salty water is dense and sinks to the bottom of the ocean while warm water is less dense and remains on the surface.
The ocean conveyor gets its “start” in the Norwegian Sea, where warm water from the Gulf Stream heats the atmosphere in the cold northern latitudes. This loss of heat to the atmosphere makes the water cooler and denser, causing it to sink to the bottom of the ocean. As more warm water is transported north, the cooler water sinks and moves south to make room for the incoming warm water. This cold bottom water flows south of the equator all the way down to Antarctica. Eventually, the cold bottom waters returns to the surface through mixing and wind-driven upwelling, continuing the conveyor belt that encircles the globe.
Answer:12
Step-by-step explanation:6x2=12
The angle RAT which is made with AR and AT line and shown in the figure of protector, measures 30 degrees.
<h3>How to measure the angle in protector?</h3>
Protector is the most useful device to measure the angle between two lines. To measure the angle between two lines using the protector following steps is followed:
- Place the protector center point at the vertex of unknown angle.
- One side of angle should be place at 0 mark line of this device.
- Other side of angle will be equal to the angle shown in protector on that line.
In the given figure, The angle Between AR and AT line is 30 degrees shown in protector.
Thus, the angle RAT which is made with AR and AT line and shown in the figure of protector, measures 30 degrees.
Learn more about the protector here:
brainly.com/question/1161640
#SPJ1
