Answer: 27.09 ppm and 0.003 %.
First, <u>for air pollutants, ppm refers to parts of steam or gas per million parts of contaminated air, which can be expressed as cm³ / m³. </u>Therefore, we must find the volume of CO that represents 35 mg of this gas at a temperature of -30 ° C and a pressure of 0.92 atm.
Note: we consider 35 mg since this is the acceptable hourly average concentration of CO per cubic meter m³ of contaminated air established in the "National Ambient Air Quality Objectives". The volume of these 35 mg of gas will change according to the atmospheric conditions in which they are.
So, according to the <em>law of ideal gases,</em>
PV = nRT
where P, V, n and T are the pressure, volume, moles and temperature of the gas in question while R is the constant gas (0.082057 atm L / mol K)
The moles of CO will be,
n = 35 mg x x
→ n = 0.00125 mol
We clear V from the equation and substitute P = 0.92 atm and
T = -30 ° C + 273.15 K = 243.15 K
V =
→ V = 0.0271 L
As 1000 cm³ = 1 L then,
V = 0.0271 L x = 27.09 cm³
<u>Then the acceptable concentration </u><u>c</u><u> of CO in ppm is,</u>
c = 27 cm³ / m³ = 27 ppm
<u>To express this concentration in percent by volume </u>we must consider that 1 000 000 cm³ = 1 m³ to convert 27.09 cm³ in m³ and multiply the result by 100%:
c = 27.09 x x 100%
c = 0.003 %
So, <u>the acceptable concentration of CO if the temperature is -30 °C and pressure is 0.92 atm in ppm and as a percent by volume is </u>27.09 ppm and 0.003 %.
They are all equally dense because they are made of the same material with the same molecular composition.
Answer:
C.) It dissolves into Hydroxide ions in water (OH-)
Explanation:
A.) is incorrect because acids dissolve into hydrogen ions, not bases.
B.) is incorrect because acids have a pH lower than 7. Bases have a pH higher than 7.
C.) is correct because this is the defining characteristic of bases.
D.) is incorrect because bases can dissolve oils. This means they can be mixed.
Answer:
The solution becomes diluted.
Explanation:
When you add water to a solution, the number of moles of the solvent stays the same while the volume increases. Therefore, the molarity decreases.
Hope this helps!
Answer:
It’s b even check quizzes
Explanation: