Answer: slope m=-1
Step-by-step explanation:
Answer:
Similarly: you start with an endpoint on both lines to start construction.
Difference: bisector you open the compass to more than half but with congruent you open the compass to the whole length
Step-by-step explanation:
Segment bisector
1. Open a Compass so it's width is more than half the length of the given segment
2. Without changing its width use the compass to draw an arc above and below the given line segment from one of the segment endpoints
3. Again without changing its width use the compass to draw another pair of arcs from the other and points. One arc will be above the segment while the second arc will be below
4. Draw the point of intersection between the pair of arcs below the line segment in between the pair of arcs below the line segment
5. Use a straight edge to connect the intersection points between each pair of arcs
congruent segment
1. Open the compass to it width that matches the given line segment
2. Using a straight edge draw a line that is longer than the given segment was one end point
3. Without changing the width of the compass use the compass to draw an arc on the Ray from its end point
Answer:
165 intreset 1265 total
Step-by-step explanation:
I = P*R*T
1100*.05*3
A counterexample could be -2.
-2+-2= -4
-4<-2
Hope this helps!
12 goes into 68 5 times, so put 5 on the top, and subtract 600 from 688. You will get 88 as your difference. 12 goes into 88 7 times, and since 12 times 7 is 84, put 84 under 88 and subtract it from 88. Your remainder will be 4.
Hope this helps!
(I have an example below)