Answer:
100 MOV Si, 500
101 MOV CL [Si]
102 MOV CH,00
103 INC SI
104 MOV AL,[SI]
105 A MOV BL, AL
105 C MUL AL
105 E MUL BL
106 MOV [SI], AL
107 INC SI
108 LOOP 104
109 HLT
The above is the required ALP program.
Explanation:
Step1: Sets the SI value to 500
Step 2: Loads the data from the SI offset to the CL register
Step 3: Increase the SI value by 1
Step 4: Move the value of the register from AL to BL
AL is the single 8-bit register
Step 5: Multiply the AL by AL
Step 6: Multiply the value of the register AL by BL
Step 7: The value of the AL is stored at the SI offset.
Step 8: Now the value of the SI is increased by 1.
LOOP 104: The program now jumps to the address 104 if the CX=CX -1 and CX is not 0.
HLT: means stop
