1answer.
Ask question
Login Signup
Ask question
All categories
  • English
  • Mathematics
  • Social Studies
  • Business
  • History
  • Health
  • Geography
  • Biology
  • Physics
  • Chemistry
  • Computers and Technology
  • Arts
  • World Languages
  • Spanish
  • French
  • German
  • Advanced Placement (AP)
  • SAT
  • Medicine
  • Law
  • Engineering
brilliants [131]
4 years ago
8

Based on its location in the periodic table, we know that ALL BUT one property applies to the element radon. Which property does

not apply to radon?
A) synthetic
Eliminate
B) radioactive
C) nonreactive
D) gas at room temperature
Computers and Technology
2 answers:
gavmur [86]4 years ago
8 0

answer A synthetic i answered it and i was right

blsea [12.9K]4 years ago
6 0
Radon is not synthetic! It is produced naturally by the decay of uranium and radium. Radon is used in treating cancer - it is radioactive, nonreactive and a gas at room temperature.
You might be interested in
Computer A has an overall CPI of 1.3 and can be run at a clock rate of 600 MHz. Computer B has a CPI of 2.5 and can be run at a
kirill115 [55]

Answer:

Check the explanation

Explanation:

CPI means Clock cycle per Instruction

given Clock rate 600 MHz then clock time is Cー 1.67nSec clockrate 600M

Execution time is given by following Formula.

Execution Time(CPU time) = CPI*Instruction Count * clock time = \frac{CPI*Instruction Count}{ClockRate}

a)

for system A CPU time is 1.3 * 100, 000 600 106

= 216.67 micro sec.

b)

for system B CPU time is =\frac{2.5*100,000}{750*10^6}

= 333.33 micro sec

c) Since the system B is slower than system A, So the system A executes the given program in less time

Hence take CPU execution time of system B as CPU time of System A.

therefore

216.67 micro = =\frac{2.5*Instruction}{750*10^6}

Instructions = 216.67*750/2.5

= 65001

hence 65001 instruction are needed for executing program By system B. to complete the program as fast as system A

3 0
3 years ago
Write a program to input elements of 4*3matrix and prints its elements properly using array ​
Harlamova29_29 [7]

Answer:

Step by step explanation:

7 0
2 years ago
I plugged my headphones into my computer, but the sound still came out of the speakers. help!
VARVARA [1.3K]

If you mean speakers. You should remove them or if you mean the speakers in the PC. Perhaps you put the headphones in the wrong one. Theres usually too one in the front and the other one in the back of the desktop.





Hope this helps.


Regards. Shaggy


Enjoy your music!

3 0
3 years ago
Read 2 more answers
1.<br> The correct way to use a seat belt is
Nesterboy [21]

Answer:

4 steps

Explanation:

Step 1: Pull belt across body

Sit in any of your vehicle's seats and secure the three-point harness in its buckle by pulling it across your body.

If the seatbelt is too short, consider an aftermarket restraint and extender. Make sure they meet federal safety standards and are installed professionally.

Step 2: Adjust lower belt

Adjust the lower belt snuggly across your lap and pelvis area – never your stomach.

Pregnant women should wear the lap belt below their belly, not on or above it.

Step 3: Adjust shoulder belt

Adjust the shoulder belt to fit comfortably across the collarbone and chest. It should never rub on your neck or face. Never put the shoulder belt behind your back or under your arm.

Step 4: Check before driving

Check that the belt is secure before driving.

4 0
3 years ago
A student is recording a song on her computer. When the recording is finished, she saves a copy on her computer. The student not
denis23 [38]

Answer:

A. The song was saved using fewer bits per second than the original song.

Explanation:

A song can be recorded on the computer or any device ranging from bit rates 96 kbps to 320 kbps.  

The lesser the bitrates the lesser the quality of the audio and when we increase the bit rates, the quality of the audio recorded gradually increases.

Bitrates of 128 kbps give us a radio like quality whereas when we use bitrates of 320 kbps we get very good or CD-like quality.

According to the scenario, the most appropriate answer is option A.

3 0
3 years ago
Other questions:
  • Help asap. 10 points.
    8·2 answers
  • Write a loop that reads positive integers from standard input and that terminates when it reads an integer that is not positive.
    10·1 answer
  • Another important mode, XTS-AES, has been standardized by the __________ Security in Storage Working Group. a. IEEE b. ITIL c. N
    9·2 answers
  • Is a type of bullying that takes place when a person intentionally posts negative information about another that is not true
    8·1 answer
  • 2.1 Changes in which factors could cause aggregate demand to shift from AD to AD1? What could happen to the unemployment rate? W
    8·1 answer
  • Who began digitizing books on a massive scale and putting them online?
    8·1 answer
  • Please Help meeeeeeeeeee:
    11·2 answers
  • PLEASE ANSWER
    6·1 answer
  • Another name of computer program is
    6·1 answer
  • What can I do If my Texas Instrument TI-84 calculator is not giving accurate answers?
    6·1 answer
Add answer
Login
Not registered? Fast signup
Signup
Login Signup
Ask question!