Answer:
The distance between the points is approximately 6.4
Step-by-step explanation:
The given coordinates of the points are;
(2, -2), and (6, 3)
The distance between two points, 'A', and 'B', on the coordinate plane given their coordinates, (x₁, y₁), and (x₂, y₂) can be found using following formula;

Substituting the known 'x', and 'y', values for the coordinates of the points, we have;

Therefore, the distance between the points, (2, -2), and (6, 3) = √(41) ≈ 6.4.
The best way to do this is to make up values for the sides.
Say the lengths of square B's sides are each 4 cm. That means A's sides are 2 cm.
So, the area of square B is 4^2 = 16 cm^2, and A's area is 4 cm^2. We can see the shaded area is half of A, so it's 2 cm^2.
What percent of 16 is 2?
2 / 16 * 100 = 12.5%
Graphs of y = x+- 1 and of y = x - 1 are shown in the figure below.
The intersection of the two graphs is the solution for the two equations.
Answer:
There is no solution.
Explanation:
It is clear that the two lines are parallel and will never intersect.
Note that the equation for a straight line is of the form
y = mx + b
where
m = slope,
b = y-intercept.
y = x + 1 has slope of m=1.
y = x - 1 has slope of m=1.
The two slopes are equal.
Because parallel lines do not intercept, there is no solution.
Check the picture below, so let's check the equations below hmmm
![\boxed{A}\\\\ y=\cfrac{16-3x}{4}\implies y=\cfrac{-3x+16}{4}\implies y = \cfrac{-3x}{4}+\cfrac{16}{4}\implies y=-\cfrac{3}{4}x\stackrel{\stackrel{b}{\downarrow }}{+4}~\hfill \bigotimes \\\\[-0.35em] ~\dotfill](https://tex.z-dn.net/?f=%5Cboxed%7BA%7D%5C%5C%5C%5C%20y%3D%5Ccfrac%7B16-3x%7D%7B4%7D%5Cimplies%20y%3D%5Ccfrac%7B-3x%2B16%7D%7B4%7D%5Cimplies%20y%20%3D%20%5Ccfrac%7B-3x%7D%7B4%7D%2B%5Ccfrac%7B16%7D%7B4%7D%5Cimplies%20y%3D-%5Ccfrac%7B3%7D%7B4%7Dx%5Cstackrel%7B%5Cstackrel%7Bb%7D%7B%5Cdownarrow%20%7D%7D%7B%2B4%7D~%5Chfill%20%5Cbigotimes%20%5C%5C%5C%5C%5B-0.35em%5D%20~%5Cdotfill)

Answer: The y-intercept should be the $20. The equation would be y=10x+20. Not sure if that’s what you’re asking.
Step-by-step explanation: