The three previous manufacturing revolutions that Mr. Scalabre mentioned and their year of occurrence are:
- The steam engine in the mid-19th Century
- The mass-production model in the early 20th Century
- The first automation wave in the 1970s
<h3>What is a Manufacturing Revolution?</h3>
This refers to the process of change from a handicraft economy to industry production-based production.
Hence, we can see that Mr. Scalabre believes we are not growing in productivity because there has not been enough automation to perform the tasks needed.
The effect of robotics is making an impact on productivity because a lot of complex, difficult tasks are done by machines.
3D printing has made an impact on productivity because there is a reduction in the pressing cycle and errors due to negligence are reduced.
The role the engineers have to play in the next revolution is that they would have to produce mathematical model that can be used to produce better AIs
Read more about manufacturing revolutions here:
brainly.com/question/14316656
#SPJ1
Answer:
The correct response will be "0.992". The further explanation to the following question is given below.
Explanation:
The probability that paging would be beneficial becomes 0.8
Effective paging at the very first attempted is 0.8
On the second attempt the success probability will be:
⇒ 
⇒ 
On the third attempt the success probability will be:
⇒ 
⇒ 
So that the success probability will be:
⇒ 
⇒ 
Answer:
Fleming hand rule represents the direction of current in a generator's windings and induced current as a conductor is attached to a circuit such that it moves in a magnetic field.
Explanation:
Fleming hand rule represents the direction of current in a generator's windings and induced current as a conductor is attached to a circuit such that it moves in a magnetic field.
Fleming hand rule is used in the case of electric motors and electric generators.
Fleming hand rule is used to determine the following:
1. Direction of torque
2. Angular velocity
3. Angular acceleration
Answer:
The correct option is;
Neither Technician A nor B
Explanation:
The evaporative emission monitor or Evaporaive Emission Control System EVAP System monitors enables the Power Control Module of the car to check fuel system leak integrity and the vapor consumption efficiency during engine combustion
It is a requirement of EPA on cars to check the emission of smug forming evaporates from cars
Serious monitor faults can cause the turning on of the check engine lights and the vehicle will not pass OBD II test, but it will not lead to engine shutdown
It runs when the engine is 15 to 85% full and the TP sensor is between 9% and 35%.
Therefore, the correct option is that neither Technician A nor B are correct.
Answer:
(a) Calculate the rod base temperature (°C). = 299.86°C
(b) Determine the rod length (mm) for the case where the ratio of the heat transfer from a finite length fin to the heat transfer from a very long fin under the same conditions is 99 percent. = 0.4325m
Explanation:
see attached file below
