Answer:
Yes, The overall cost of wiring in addressable fire alarm system is significantly cheaper than the conventional one.But the addressale fire alram system is more reliable than a conventional system.
Explanation:
Conventional systems are hardware-based and use analog technology. where addressable fire alarm use digital technology. addressable system is generally more reliable than a conventional system mainly due to how the different systems are wired. With a conventional system, if a device’s wire is damaged or severed, its signal and the signal of other devices down the line cannot be transmitted to the control panel.
With an addressable system, both ends of the wire connect to the control panel. Therefore, if one end becomes damaged or severed, signals can still reach the control panel through the other end of the loop. In addressable systems, a device can be removed or disabled and it will not affect the other devices in the loop.
Answer:
1. Processor communication -- this involves the following tasks:
<em>a. exchange of data between processor and I/O module</em>
<em>b. command decoding - I/O module accepts commands sent from the processor. E.g., the I/O module for a disk drive may accept the following commands from the processor: READ SECTOR, WRITE SECTOR, SEEK track, etc. </em>
<em>c. status reporting – The device must be able to report its status to the processor, e.g., disk drive busy, ready etc. Status reporting may also involve reporting various errors. </em>
<em>d. Address recognition – Each I/O device has a unique address and the I/O module must recognize this address. </em>
<em />
2. Device communication – The I/O module must be able to perform device communication such as status reporting.
3. Control & timing – The I/O module must be able to co-ordinate the flow of data between the internal resources (such as processor, memory) and external devices.
4. Data buffering – This is necessary as there is a speed mismatch between speed of data transfer between processor and memory and external devices. Data coming from the main memory are sent to an I/O module in a rapid burst. The data is buffered in the I/O module and then sent to the peripheral device at its rate.
5. Error detection – The I/O module must also be able to detect errors and report them to the processor. These errors may be mechanical errors (such as paper jam in a printer), or changes in the bit pattern of transmitted data. A common way of detecting such errors is by using parity bits.
Where ARE the books that you borrowed?
Answer:
The recommended type of trunk for interoperability is an IEEE 802.1Q trunk.
Explanation:
IEEE 802.1Q is an open industry standard and is the most commonly implemented on layer 2 switches of different vendors, assuring interoperability.
Commonly know as <em>dot1q</em>, is the networking standard that supports virtual LANs (VLANs) on an IEEE 802.3 Ethernet network. It specifies the mechanisms for tagging frames with VLAN data and the procedures for handling this data by switches and bridges.
Answer:
By being a part of a block to a block chain and each block in the block chain is precisely connected to the block that was before it.
Explanation:
I Hope This Helps You
