Answer:
4
Step-by-step explanation:
Answer: 1.25
explanation: you multiply the amount of fabric used for one by the amount of potholders
.125 x 10 = 1.25
The pool has a diameter 20 ft so: r = 10 ft.
The pool cover extents 12 inches beyond the edge of the pool.
12 inches = 1 foot
Therefore, the radius of the pool cover is : r = 10 + 1 = 11 ft.
a. The area of the pool cover:
A = r² π = 11² π = 121 π ft²
b. The length of the rope:
l = 2 r π = 2 · 11 π = 22 π ft.
The steps to use to construct a frequency distribution table using sturge’s approximation is as below.
<h3>How to construct a frequency distribution table?</h3>
The steps to construct a frequency distribution table using Sturge's approximation are as follows;
Step 1: Find the range of the data: This is simply finding the difference between the largest and the smallest values.
Step 2; Take a decision on the approximate number of classes in which the given data are to be grouped. The formula for this is;
K = 1 + 3.322logN
where;
K= Number of classes
logN = Logarithm of the total number of observations.
Step 3; Determine the approximate class interval size: This is obtained by dividing the range of data by the number of classes and is denoted by h class interval size
Step 4; Locate the starting point: The lower class limit should take care of the smallest value in the raw data.
Step 5; Identify the remaining class boundaries: When you have gotten the lowest class boundary, then you can add the class interval size to the lower class boundary to get the upper class boundary.
Step 6; Distribute the data into respective classes:
Read more about frequency distribution table at; brainly.com/question/27820465
#SPJ1
