Disruptive selection or diversifying selection describes the changes in population genetics where extreme values for a trait are favored over intermediate values.
So according to this definition, the conclusion can be derived as :
The most common circumference(s) to be after 10 generations of diversifying selection will be greater than 2 cm and less than 2 cm.
 
        
             
        
        
        
Answer:
C U A G C U A U G G U A A G C C G C G U A U G A A G C
Explanation:
this is the complementary strand in mRNA.
A=U
G=C
C=G
T=A
this is the answer key to any mRNA strand.
Hope this helps! :)
 
        
             
        
        
        
Answer:
Ice cream , peanut butter or melted marshmallows with puffed rice- cereal
Explanation:
can all work for the mantle layer of your project. Push a hard candy representing both the inner core and outer core into a ball of ice cream, or spoon a layer of ice cream into a clear plastic cup over the top of the inner and outer core.
Hope it helps 
 
        
             
        
        
        
Answer:
A student has been studying electrical circuits in class. The student suggests that replacing a wire with rubber tubing will stop the current from flowing through a circuit. Which term best describes this idea?
Hypothesis
Explanation:
From the analogy, it is expedient to know that the student assertion about the electrical circuits was an hypothesis because it gives room for further investigation by other scholars.
 
        
             
        
        
        
Answer:
42,5 mL
Explanation:
We need to use the serial dilution formula beacuse we start with a stock concentrate solution and we need to prepare a new less concentrated one. 

<u>DF in the dilution factor, Vi is the initial volume and Vf is the final volume.</u>
The first step is to have the same measurment unit so we need to convert 345 µg to mg. 
we know that 1 µg equals 0,001 g, hence: 

now the final volume is 0,345 mg  protein/ mL and the inital volume is 15mg protein/mL, both of them are in the same unit so we can use the formula


 Now since the question said that we already have 1.0mL of the amylase stock solution we need to subtract that 1.0mL to the 43,5 mg protein/mL 

So, we need 42,5 mL of diluting buffer if we want a final concentration of 345 µg protein/mL (0.345 mg protein/mL)