Answer:
Neither A nor B
Explanation:
<em>Reserve capacity</em> is the number of minutes that a new, fully charged battery can discharge continuously and maintain a terminal voltage equal to or greater than 1.75 volts per cell.
<em>An ampere-hour </em>is an electric charge unit and its abbreviation is Ah.
It measures the amount of electric charge flowing through a battery in the case that amount supplies a current of 1 amp for 1 hour.
Explanation: The numbers in a hex are the same as decimal numbers: 0, 1, 2, 3, 4, 5, 6, 7, 8, 9. The big difference between a hex and a decimal is that a hex also contains letters. These letters are: A, B, C, D, E, F. A hex number can be represented using a subscript of 16.
Answer:
Risk management is the technique that is used for managing the risky situation so that security of the system or organization can be maintained. The risk can be reduced by parameters like monitoring the system,alertness, preventive measures etc. There are terms related with the risk management for prevention of the risk such as risk control ,risk identification and risk assessment .
- Risk control is the method that is used for calculating the loss or damage experience and then taking the correct measures to reduce the loss and thus, controlling the risk.
- Risk assessment is the analyzation of the threats and source of damage/loss that is caused or can be caused by assessing the whole process and functioning.
- Risk identification is the technique through which the threat is listed over a document and sorted in accordance with the category of risk, risk response etc.
A partial dependency exists.
We have two types of dependency. The partial dependency and the transitive dependency.
The answer here is partial dependency. It occurs when the attribute only depends on some parts of the element. In such attribute, the primary key is the determinant.
It can be shown as;
XY→WZ , X→W and XY is the primary key or the only candidate key
Read more at brainly.com/question/9588869?referrer=searchResults
Answer:
if(y==10)
{
x=0; // assigning 0 to x if y equals 10.
}
else
{
x=1; // assigning 1 to x otherwise.
}
Explanation:
In the if statement i have used equal operator == which returns true if value to it's right is equal to value to it's left otherwise false.By using this operator checking value of y and if it is 10 assigning 0 to x and if it is false assigning 1 to x.
