Answer:
Physical layer is the first layer of OSI model. The detail about physical layer and its parts is given below in explanation section.
Explanation:
The physical layer is the lowest and first layer of the Open Systems Interconnection Model (OSI). The physical layer is used for the transmission of data in bit forms. For transmission of data between devices, it uses the transmission medium that is either wired or wireless.
In the wired cable the component of the psychical layer include cable and connectors that are implemented for carrying data from one place to another or simply to transmit data between two connected devices. The wireless transmission medium is used to transmit data in the form of electromagnetic signals for carrying data into a stream of bits. Over past advancements in networking technologies, rapid growth has been seen in wireless data transmission and Wi-Fi and Bluetooth communication are few names of it.
Components/Parts of Psychical Layer
In the physical layer, the hardware components used it in are the network interface cards, connectors and interfaces, intermediate devices, modems, and cables to facilitate the transmission of data between devices or from source to destination.
- The network interface card (NIC)
NIC is a component installed in the computer to connect it to any available devices over the network.
- Connectors and Interfaces
Connectors and interfaces are used to connect cables that are being used for transmission of data from one source to another. The decision to choose connectors and interfaces depends on the type of cable. Typical examples are RJ-45, RJ-11, V.35, HDMI, etc.
Cables are the physical components of the physical layer that carry optic or electromagnetic signals for transmission of data from source to destination in the network.
The intermediate devices are hubs and repeaters etc. The functions of these devices are to amplify or generate the signal at the intermediate point in a network.
Answer:
"Compliance audit
" seems to be the correct answer.
Explanation:
- A compliance or enforcement audit seems to be a systematic analysis of the conformity of such an agency to the reporting requirements and guidelines.
- In a compliance audit, independent auditors determine the extent and completeness of enforcement plans, security protocols, user authentication, including risk management framework.
Answer:
Option d num = 50, min = 50, max = 50
Explanation:
Given the code segment:
- boolean isBigger;
- boolean isSmaller;
- boolean inRange;
- if (num < max)
- {
- isSmaller = true;
- }
- else {
- isSmaller = false;
- }
-
- if (num > min)
- {
- isBigger = true;
- }
- else {
- isBigger = false;
- }
-
- if (isBigger == isSmaller) {
- inRange = true;
- } else {
- inRange = false;
- }
If we have num = 50, min = 50 , max = 50, the condition num < max will be evaluated to false and therefore isSmaller is set to false.
The condition num > min will be evaluated to false as well and therefore isBigger is set to false.
Since isSmaller and isBigger are both false and therefore isBigger == isSmaller will be evaluated to true and set the inRange = true. This has violated the statement that if the integer value num is greater than min value and less than max value, then only set inRange to true. This is because num = 50 is neither greater than min nor less than max, it is supposedly not in range according to the original intention of the code design.
Answer: use Microsoft Power Point
Explanation:
Set up a self-running presentation
To set up a PowerPoint presentation to run automatically, do the following:
On the Slide Show tab, click Set Up Slide Show.
Under Show type, pick one of the following:
To allow the people watching your slide show to have control over when they advance the slides, select Presented by a speaker (full screen).
The answer in the blank is HTML or also referred to as
Hypertext Markup Language as this is always included with the World Wide Web
pages for they are always essential and needed. It is because it is a
standardized system that would help the resources of the internet that is to be
displayed on the page.
