Conventional volcanoes are known to erupt after pressure builds up from new magma flowing into the magma chambers that lie below the vents on the Earth's surface.
The answer would be 371 because it has multiple complete digits
Answer:
6.82 g H₂S
General Formulas and Concepts:
<u>Math</u>
<u>Pre-Algebra</u>
Order of Operations: BPEMDAS
- Brackets
- Parenthesis
- Exponents
- Multiplication
- Division
- Addition
- Subtraction
<u>Chemistry</u>
<u>Atomic Structure</u>
<u>Stoichiometry</u>
- Using Dimensional Analysis
Explanation:
<u>Step 1: Define</u>
0.200 mol H₂S
<u>Step 2: Identify Conversions</u>
Molar Mass of H - 1.01 g/mol
Molar Mass of S - 32.07 g/mol
Molar Mass of H₂S - 2(1.01) + 32.07 = 34.09 g/mol
<u>Step 3: Convert</u>
- Set up:
- Multiply:
<u>Step 4: Check</u>
<em>Follow sig fig rules and round. We are given 3 sig figs.</em>
6.818 g H₂S ≈ 6.82 g H₂S
Answer:
see explanation
Explanation:
Ice usually has tightly packed molecules at a low temperature. When it comes in contact with a higher temperature or room temperature, the ice molecules gain energy and the molecular tension increases which causes the state to change to liquid. Therefore, a <u>high temperature</u> causes an ice block to melt.
You have to be very careful with this question. A change in mass can also occur in chemical changes especially if you have too much of something. For example
CH4 + 1.5 02 ===> CO2 + H2O
If you have too much of either CH4 or O2, there will be some CH4 or O2 left over. There has been a change in mass that you have too much of.
However that is not the point of the question. It is just something you need to be aware of.
Suppose you have a piece of aluminum and you take a course grinder after it. You will change the texture of the side you took the grinder to. If the aluminum has been anodized (a color has been put on it's surface), you may grind the color off or if it is just plain aluminum, you may roughen the surface, but you won't change what the aluminum will do chemically.
You may need only a small portion of the aluminum and you grind off just what you need. That will change the mass of both what you took off and the piece that you want, but the aluminum will still do whatever chemical property you need to use.
So you can change both texture and mass without changing the chemical properties of the substance whose mass or texture you are changing.
