From the graph, the coordinates of the cross that represent this car on the graph are ( 8, 2100).
<h3>What is the correlation coefficient?</h3>
The correlation coefficient is a measure of how similar two datasets are acting.
When the correlation coefficient comes out as -1, it means that both the datasets are negatively oppositely correlated.
One data increases and other data starts to decrease in the opposite direction.
When the correlation coefficient comes out below 0, values are negatively correlated.
The correlation shown by the graph is negative.
From the graph, the coordinates of the cross that represent this car on the graph are ( 8, 2100).
Learn more about correlation coefficient here:
brainly.com/question/10725272
#SPJ1
I'm guessing the 20 percent off is from the $36.81 so you take 36.81 times 0.80 making it $29.448. Take 90 dollars and minus that amount.
Answer: $60.552
Rounded Answer: $60.55 or $60.60 or $61
Not sure if this helped, but yeah.....
9514 1404 393
Answer:
y = -x +5
Step-by-step explanation:
Solving the given equation for y, we have ...
y = x +4
The slope of this line is the coefficient of x: 1. The slope of the perpendicular line will be the opposite reciprocal of this: -1/1 = -1. The y-intercept of the perpendicular line can be found from ...
b = y -mx = 8 -(-1)(-3) = 5
The perpendicular line has equation ...
y = -x +5
Answer:
900
Step-by-step explanation:
(n-2)*180
5*180=900
Answer:
The ray that goes parallel to the main axis after passing through the lens should also be parallel from the object to the lens
Step-by-step explanation:
To form the image of an object using a convex lens, ray diagrams are used. The following steps are followed when drawing ray diagrams.
1) Light rays are drawn from the object incidented on the lens and parallel to the principal axis. The incident light refracts (bends) through the lens and converges at the focal point at the other side of the lens.
2) Another incident light passes through the optical centre undeflected and intersect with the refracted ray at the other side of the lens.
Based on the above points, Roshan made an error by drawing the ray that goes parallel to the main axis and after passing through the lens made the same ray to be parallel from the object to the lens instead of refracting (bending) after passing through the lens.
