Answer: -3 and 12
Step-by-step explanation:
First: your +12 is where you start
Your coordinates for that is (0,12) so, put one point on (0,12)
Second: your slope is -3. So at (0,12) you go down -3 and go to the right 1.
Connect the dots to make your line and you are finished!!
Hope this helps!! :)
Answer:
Step-by-step explanation:
Given that Human visual inspection of solder joints on printed circuit boards can be very subjective. Part of the problem stems from the numerous types of solder defects (e.g., pad non-wetting, knee visibility, voids) and even the degree to which a joint possesses one or more of these defects.
Let A- event inspect A found defective , B - inspector B found defective

,
a) Probability that the selected joint was judged to be defective by neither of the two inspectors=
b) Probability that the selected joint was judged to be defective by inspector B but not by inspector A
=

Hence
P(AB')\\=P(A)-P(AB)
= 0.0766-0.0624
=0.0142
The answer is 15. 38-23= 15
That'd be 1/3 + 81, or 81 1/3, or 244/3
Answers are:
16.
-1 - (-4) = 3
17.
-1-1/3 - (-4) = 2-2/3
18.
2 - (-1) = 3
19.
3-1/2 - (-1) = 4-1/2
20.
3-1/2 - 2 .= 1-1/2
21.
3-1/2 - (-1-1/3) = 4-5/6
Step by step: I took one point and subtracted the second point to get the length of each segment. You could also look at the ruler and count from one point to the other.
Remember when you subtract a negative, the two negatives become a positive