Answer:
count_p = 0
count_n = 0
total = 0
while True:
number = int(input("Enter an integer, the input ends if it is 0: "))
if number == 0:
break
else:
total += number
if number > 0:
count_p += 1
elif number < 0:
count_n += 1
print("The number of positives is: " + str(count_p))
print("The number of negatives is: " + str(count_n))
print("The total is: " + str(total))
print("The average is: " + str(total / (count_p + count_n)))
Explanation:
Initialize the variables, count_p represens the number of positives, count_n represents the number of negatives, and total represents the total of the numbers
Create a while loop iterates until the user enters 0. If the number is not 0, then add it to the total. If the number is greater than 0, increase count_p by 1. If the number is smaller than 0, increase count_n by 1.
When the loop is done, print the count_p, count_n, total, and average
Answer:
Recommended is frame relay architecture with a local loop at each factory supporting the frame relay service connection to the network provider's POP
Explanation:
Frame Relay can be seen as WAN protocol that is said to often operate at both the physical and data layers link of the OSI reference model due to it high-performance and due to the fact that FRAME RELAY are as well use across Integrated Services Digital Network (ISDN) interfaces in which they are designed for cost-efficient data transmission in order to enable effective intermittent traffic between local area networks (LANs) and endpoints in wide area networks (WANs) which is why frame contains all the information necessary to route it to the correct destination.
Therefore type of BN and WAN architecture and WAN service i would recommend based on the above information is FRAME RELAY ARCHITECTURE with a local loop at each factory supporting the frame relay service connection to the network provider's POP.
C. schedule.
Outlook adds your appointment to your schedule folder.
Answer:
????
Explanation:
i dont speak this language
Answer:
You can assign a value to a routine variable in any of the following ways:
Use a LET statement.
Use a SELECT INTO statement.
Use a CALL statement with a procedure that has a RETURNING clause.
Use an EXECUTE PROCEDURE INTO or EXECUTE FUNCTION INTO statement.
Explanation:
