In geometry, "construct" means do it with a straightedge (not a ruler) and compass.
Here's how you do it:
1. Using the straightedge, draw a line clearly longer than segment RS.
2. Place a dot at one end of the line you drew.
3. Stick the "center" of your compass in the R position of the RS segment.
4. Open the compass so the pencil point passes through the S position. Your compass now marks off segment RS.
5. Without opening or closing the compass, pick it up and stick the center into the dot you made on your new line.
6. Still without opening or closing the compass, make a hash mark that crosses your new line.
7. Place a dot where the hash mark crosses the line. The segment on the new line between the two dots is a segment congruent to RS.
Notice that you didn't use a ruler to measure anything. This is called a "construction" in geometry. It's what the ancient Greeks used to do.
Answer: y= -3
Step-by-step explanation: some things you have to do alone my good man
Answer:
15x^2y^2+9x^2y+2xy^2+27xy
Step-by-step explanation:
Direct.
Direct is when one part of data goes up, so does the other.
Inverse is when one goes up, the other goes down.
The table shows that as x goes up, so does y.
Hope this helps!
9, 9(2)=18, 9(3)=27, 9(4)=36 9(5)=45
9,18,27,36,45……..144
Not sure if this is what you are looking for. If the number of blanks is the amount of numbers allowed then the above will not work
9(13)=117, 9(14)=126, 9(15)= 135, 144
If you can only have 3 blanks then the second one could work.
Again, not sure if this is what you need. But hopefully it helps.
