Answer: it is 2 and 3 are the right answer's To the question i believe
Answer:
B)because otherwise the packets will bounce back and forth from end to end repeatedly
Explanation:
Bus topology can be regarded as a kind of topology for a Local Area Network, it is one that has it's nodes connected to a single cable(backbone) and any break in the so called backbone, there will be failure in the entire segment. However a Terminator is usually attached to the end-points of a bus network so that the signal is absorbed by the Terminator and as a result of this the signal will not reflect back down the line. If there is no Terminator there would be bouncing back and forth of packet in an endless loop.It should be noted that a bus topology require a terminator because otherwise the packets will bounce back and forth from end to end repeatedly
.
<span>An objective test or measurement that technology product evaluators use to compare two or more products is benchmark. The benchmark is set of standards which are used to compare two products. Several parameters are measured in order to compare the products and to define the weak points where improvements can be done. The obtained information form the test is used to improve performance. </span>
Answer:
Option e: The use of programmed decisions should be limited to noncritical situations.
Explanation:
A repetitive decision or routine that can be managed by developed business procedures or rules are known as programmed decisions. These kind of decisions are most often known for at certain points in a standard process, and are planned relying on recognized and easily identifiable terms. Programmed decisions generally do not demand much consideration or discussion, and can typically be automated to make certain consistency and save time for decision-makers.
So, the use of programmed decisions should not be limited to noncritical situations.
