Answer:
You are probably blocked from that website or your schools program blocks that website from your device
Explanation:
Answer:
Trap is a software interrupt that occurs when there is a system call, while hardware interrupt occurs when a hardware component needs urgent attention.
Explanation:
Interrupt is an input signal that disrupt the activities of a computer system, giving immediate attention to a hardware or software request.
In trap interrupt, the system activities are stop for a routine kernel mode operation, since it has a higher priority than the user mode. At the end of the interrupt, it switches control to the user mode.
The hardware interrupt is a signal from hardware devices like the input/output devices, storage and even peripheral devices that draws an immediate attention of the processor, stopping and saving other activities and executing the event with an interrupt handler.
Answer:
the bottom third
Explanation:
Check out the exampe below.
swim() would be an example of a method.
The answer would more likely be A
If it’s not correct I’m very sorry
The decimal form of the 11001101.00111001.10101001.01000010 binary ip address is 205.57.169.66.
An IP address is a binary number with 32 bits. The 32 bits are divided into four octets, which are groupings of 8 bits each. An IP address, however, is shown as a dotted decimal number (for example: 205.57. 32.9).
Memory regions are given binary addresses by the computer system. But in order to access a memory location, the system utilises a certain number of bits. We can address two memory regions with 1 bit. We can address 4 memory locations with 2 bits and 8 memory locations with 3 bits.
The 4 sets of 8 bits in each of the 4 directions are simply written down to create the 32-bit binary IP address.
Learn more about binary ip address:
brainly.com/question/14541891
#SPJ4