Answer with Explanation:
We are given that
a.Length of segment,l=20 m
Magnetic force ,F=
Substitute the values
Hence, the magnetic force exert by each segment on the other=0.0119 N
b.We know that when current carrying in the wires are in same direction then the force will attract to each other.
Hence, the force will be attractive.
Answer:
man brainly should put a rank for having negative points
Explanation:
that would be me right now
Answer:
HOPE IT HEPLED U !!!!
Explanation:
i think it's (C) They have different units ....
Either 175 N or 157 N depending upon how the value of 48° was measured from.
You didn't mention if the angle of 48° is from the lug wrench itself, or if it's from the normal to the lug wrench. So I'll solve for both cases and you'll need to select the desired answer.
Since we need a torque of 55 N·m to loosen the nut and our lug wrench is 0.47 m long, that means that we need 55 N·m / 0.47 m = 117 N of usefully applied force in order to loosen the nut. This figure will be used for both possible angles.
Ideally, the force will have a 0° degree difference from the normal and 100% of the force will be usefully applied. Any value greater than 0° will have the exerted force reduced by the cosine of the angle from the normal. Hence the term "cosine loss".
If the angle of 48° is from the normal to the lug wrench, the usefully applied power will be:
U = F*cos(48)
where
U = Useful force
F = Force applied
So solving for F and calculating gives:
U = F*cos(48)
U/cos(48) = F
117 N/0.669130606 = F
174.8537563 N = F
So 175 Newtons of force is required in this situation.
If the 48° is from the lug wrench itself, that means that the force is 90° - 48° = 42° from the normal. So doing the calculation again (this time from where we started plugging in values) we get
U/cos(42) = F
117/0.743144825 = F
157.4390294 = F
Or 157 Newtons is required for this case.
Question:
How do mountain glaciers and continental glaciers differ in terms of dimensions, thickness and patterns of movement?
Answer:
<span>
Continental glaciers are thicker, much more expansive sheets. Mountain glaciers flow downhill as a result of gravity acting on the mass of ice. Continental glaciers move in response to pressure from the weight of material in their thick midsections.
</span>
Hope this helped!
~Shane :}
