Like D. Codon is the answer
Answer:
Explanation:
Osmosis is the process in which the molecules of a solvent move from a region of low concentration to a region of higher concentration through a semi-permeable barrier.
While eating the chips, <u>the salt content from the chips makes the surrounding solution of the cells to have an increase in salt concentration causing an hypertonic solution</u>. An hypertonic solution is a solution that has more solute (salt) than the (solute in a) cell. <u>This increase in salt concentration around the cells causes the cells to release water to neutralize the high salt concentration in the solution around the cell (in order to maintain homeostasis)</u> which causes dehydration in the individual and hence making the individual to be thirsty. <u>The body attempts to maintain balance by passing this excess salt out of the body in the form of urine hence the reason for the dark colour in the urine </u>(because if the body doesn't rid itself of the high salt concentration, the cells could shrink and die as a result).
The correct answer should be the Periderm.
It is not as simple as this, of course and you would be wise to know that periderm is just a part of the overall concept that is bark, because bark is not a biological term.
Sound quality can be divided into amplitude, timbre and pitch. If there’s an impedance mismatch between your two devices connected to the single output, you could have a large mismatch between the levels arriving at each device. If the difference is large enough, one device may have distorted or inaudible audio.
To avoid this, you should ensure that both devices connected to the split signal are similar - such as 2 pairs of headphones, 2 recorder inputs, and so on. When you place 2 devices with wildly differing load impedances on a splitter is when you’ll encounter problems - such as headphones on one split and a guitar amp input on the other.
To get around this, you can use either a distribution amplifier (D.A.) or a transformer balanced/isolated splitter - which will work over a larger range of load impedances, typically. Depends on the quality of the splitter and the exact signal path. If you’re using the splitter to hook two things into one input, and you’re using quality connectors, you probably won’t lose much quality. There can be an increase in impedance of the cable due to the imperfect continuity of the physical connection, however with unbalanced line-level signals, impedance at both ends of the chain tends to be orders of magnitude higher than the connection will create, so one split will be barely noticeable. So too, the noise increase from the additional length of cable.
Now, one source into two inputs, that will by basic math and physics result in a 3dB drop in signal strength, which will reduce SNR by about that much. By splitting the signal path between two inputs of equal impedance, half of the wattage is being consumed by one input and half by the other (the equation changes if the inputs have significantly different impedances). So each input gets half the wattage produced by the source to drive the signal on the input cable, and in decibel terms a halving of power is a 3dB reduction. Significant, until you just turn the gain back up. The “noise floor” will be raised by however much noise is inherent in the signal path between the split and the output of the gain stage; for pro audio this is usually infinitesimal, but consumer audio can have some really noisy electronics, both for lower cost and because you’re not expected to be “re-amping” signals several times between the source and output.
Answer:
A
Explanation:
this is because these photosynthetic protists have chlororphyll which is capable to make their own food materials through photosynthesis
