Answer:
B) Developer is poured down the drain while fixer can be reduced
Explanation:
The effluents produced during photographic processing includes, wash water, bleach, fixer, and developer
The developer is an alkaline solution, with a pH of approximately 10.0, while the pH of the fixer is about 4.3, it is therefore, acidic
The rate of discharge of the developer to the fixer is 2 to 1, and the exhausted developer, fixer and process effluents combined are neutral and can be handle by the the treatment works and the drain pipes
Fixer which remain clear can be reused for more than a day, while the spent basic Developer and the acidic Spent Stop Bath can be combined to form a neutral solution, having a pH of approximately 7, which make them less hazardous to be disposed off down the sink into the drain
Therefore, <em>developer is poured down the drain while fixer can be reused</em>
Answer:
Answer: C Scrum
Explanation:
Answer: C Scrum would BEST support this objective, to collect and evaluate user stories related to the organization’s internally designed CRM tool.
Answer:
A weak fuel to air mixture along with normal airflow through a turbine engine may result in <u>a lean die out</u>.
Explanation:
Lean die out is a type of problem that may occur in the turbine. This may result in the weak fuel to air mixture. In case if the mixture of fuel and air is getting low due to some reasons like leakage of gas or low speed of engine may result in dangerous conditions such as fire or blast in the turbine. This is called lean die out. In the result of this problem, the turbine can be burn with the blast and may leads to causalities.
Answer
5 bits
Explanation
A bit is the least or the smallest unit of data in a computer. They are the units of information in information theory, consisting of the amount of information required to specify one of two alternatives 0 and 1. This is because A bit has a single binary value, either 0 or 1
If you use roman alphabet A to Z lets use log 2(26)=4.7 bits. when you round off it will be 5 bits.
Answer:
1. You want to use parameters
2. You don't want your program to run multiple times
3. You want to call that snippet of code throughout your program
hope this helped :D
