Answer:
A company produces electric insulators. The strength of the insulators is important since a broken insulator may cause a short circuit. Unfortunately, the strength varies significantly due to the material. Because of the expense, only a limited number of insulators could be tested. The engineers sampled 25 insulators (From a production run of 200), and conducted a destructive test to determine the force that was required to break the insulators. The mean value of this force was 1723 lbf with a sample standard deviation of 90 lbf. You may approximate the population standard deviation with the sample standard deviation for the following questions. a. Determine if the population is large enough or if a finite population correction (FPC) factor is needed. If so, what is the FPC factor? b. For 95% confidence, determine the margin of error (+ lbf) c. For these conditions, estimate the range of the probable population mean. Provide lower and upper values. For 95% confidence, determine the margin of error ( Assume the same mean and sample standard deviation. What is one advantage and one disadvantage of using 50 insulators instead of 25 insulators? d. lbf) if 50 insulators were tested.
Step-by-step explanation:
1:14 means that for every 1 cm it is drawn at it is actually 14 cm
so multiply 4 x 14 = 56
it is actually 56 cm wide
Answer:
Help with what
Step-by-step explanation:
Answer:
765 miles
Step-by-step explanation:
Find the rate (mph) and then multiply the result by 9 hours:
340 mi
------------- * 9 hrs = 765 miles
4 hrs
A ray in mathematics starts at a point and extends infinitely in one direction away from that point
it differes from a line because a line extend indefinitely in both directions
the sun ray starts from the sun and does not pass through the sun so it starts from a point (the sun's surface) and extends indefinitely into space unless it hits something (planets, black holes, endpoint)
