Answer:
I'm pretty sure that it is D.
Explanation:
Your welcome;)
Answer:
Use a remote control to advance slides when possible.
Explanation:
Carly gave a presentation using projector. She very clearly explained all the contents of each and every slides to the audiences and was very careful not to obstruct or block the projection. Carly was going very well with her presentations, when she found that two of her slides were out of order and became nervous. But she managed to recover them quickly.
The guideline that I can provide her to improve her presentation skills is to use a remote control when advancing slides. In this way she can show her slides in the projector in order without any mistakes. Also she can check the order of her slides before the beginning of the presentation in order to avoid last minute hassle.
The remote control will advance the slides accurately and orderly.
Thus the answer is ---
Use a remote control to advance slides when possible.
Answer:
A i think if it is wrong than my fault
Explanation: MOV instruction copies a word or byte from a specified source to a specified destination. The destination can be a register or a memory location. The source can be a register or a memory location or an immediate number .
For MOV CX 037AH: put immediate number 037AH to CX
For MOV BL, (437AH) : copy byte in Ds at offset 437AH to BL
For MOV AX BX : copy content register BX to AX
For MOV DL, (BX) : copy byte from memory at(BX) to DL
That identifies the differences. Good luck.