Answer:
Goodness of fit
Step-by-step explanation:
Given
The theoretical probabilities
<em>See comment for complete question</em>
<em></em>
Required
The type of test to be use
From the question, we understand that you are to test if the die is loaded or not using the given theoretical probabilities.
This test can be carried out using goodness of fit test because the goodness of fit is basically used to check the possibility of getting the outcome variable from a distribution. In this case, the outcome of the variables are the given theoretical probabilities.
In a nutshell, the goodness fit of test determines if the given data (in this case, the theoretical probabilities) is a reflection of what to expect in the original population.
Answer:
you just gotta look at the angles, the middle letter is usually what's being focused on
17. angle QMR is less that TMS
18. angle QMR and angle TMS are supplementary angles
19. angle QMR and angle MTS are vertical angles
20. If measure angle QMT = 70 degrees, then measure angle RMS is 70 degrees because they are congruent
Step-by-step explanation:
Answer:
Step-by-step explanation:
Answer:
The supplier becomes less accurate than they otherwise would have tried to claim. A further explanation is below.
Step-by-step explanation:
According to the provider, this same width of that same confidence interval would be as follows:
= 
= 
Depending on the input observed, the width including its confidence interval would be as follows:
= 
= 
As even the width of that interval again for survey asserted > the width including its confidence interval according to the provider's statement, we could conclude that such is the appropriate reaction.
Answer:
The volume of the cone is 16.8 in cubed.
Step-by-step explanation:
The formula for a cone is πr^2 multiplied by h/3. The r is radius and h is height. So throwing in the values for the variables we get 16.8 in cubed.