4 Types Of Dimmers :
1. Incandescent/Halogen
2. Magnetic Low Voltage (MLV)
3. Fluorescent
4. Light Emitting Diode (LED)
These are the different types of switches :
1. A single-pole switch controls lights from a single location. ...
2. A 3-way switch provides two separate control locations and is best used with recessed lights. ...
3. A 4-way switch provides for three or more dimming locations.
4. Switches are wired to the "hot" conductor in a wall box.
<em>I hope that my answer helps!</em>
Answer:
for (int h = k; h >= 0; h--)
Explanation:
From the list of given options, option C answers the question.
In the outer loop
Initially, k = 0
In the inner loop,
h = k = 0
The value of h will be printed once because h>=0 means 0>=0 and this implies once
To the outer loop
k = 1
The inner loop will always assume value of k;
So,
h = 1
This will be printed twice because of the condition h>=0 means 1>=0.
Since 1 and 0 are >=0; 1 will be printed twice
To the outer loop
k = 2
The inner loop
h = 2
This will be printed thrice because of the condition h>=0 means 2>=0.
Since 2, 1 and 0 are >=0; 2 will be printed thrice
To the outer loop
k = 3
The inner loop
h = 3
This will be printed four times because of the condition h>=0 means 3>=0.
Since 3, 2, 1 and 0 are >=0; 3 will be printed four times
Normal or random variations that are considered part of operating the system at its current capability are <u> c. common cause variations.</u>
Explanation:
Common cause variation is fluctuation caused by unknown factors resulting in a steady but random distribution of output around the average of the data.
Common-cause variation is the natural or expected variation in a process.
Common-cause variation is characterised by:
- Phenomena constantly active within the system
- Variation predictable probabilistically
- Irregular variation within a historical experience base
It is a measure of the process potential, or how well the process can perform when special cause variation removed.
Common cause variation arises from external sources that are not inherent in the process and is where statistical quality control methods are most useful.
Statistical process control charts are used when trying to monitor and control 5- and 6-sigma quality levels.
Answer:
A wave that has been digitized can be played back as a wave over and over, and it will be the same every time. For that reason, digital signals are a very reliable way to record information—as long as the numbers in the digital signal don’t change, the information can be reproduced exactly over and over again.
Explanation:
Answer:
the answer is going to be printer
