Answer:
c) It takes a greater hydraulic head to drive the groundwater laterally to the well casing in the lower permeability aquifer
Explanation:
The groundwater are contains under the rock and in the open spaces within the rocks and the unconsolidated sediments. Aquifer refers to the underground layers of the permeable sand or rocks that transmits the groundwater below water table which provides a sufficient supply of water to the well. Groundwater is present everywhere where there is porosity in the rocks and it depends on the permeability of the rocks to allow them flow.
A drawdown cone is completed in the lower permeable aquifer deeper and narrower than the high permeable aquifer as it takes more amount hydraulic head or energy to drive groundwater to the well casing which is in the lower permeable aquifer.
Chile is the razor thin country you're talking about.
Why? Because Chile accounts more than half of the western coastline of South America.
Why again you ask? Well that's easy. Chile stands with a palatable coastline of about 2,600 miles.
Answer:
Explanation:
In the first instance, you had a logic function, which you had derived using some sort of a truth table, then reduced it using K-maps, and finally derived the simplified logic. If you had used logic gates to implement the logic, the result would have been the fact that there were a lot of logic gates used. For example, for a function of 2 variables, we would need 4 AND gates and 1 OR gate. Thus, the resulting circuitry would have looked very complex.
Whereas, if you would use a microcontroller to implement the logic, all you need would be a piece of code to run the logic. There would either be minimum number of gates (or no gates at all, depending on the logic you wanted to implement).
Thus the microcontroller would make the circuit look a lot less complex. Making the design and texting simpler and since there are now fewer components to test. Microcontrollers is that on the same piece of silicon, you could embed a lot more complex logic or program, than using purely digital gates this is another good that comes with Microcontrollers.
Answer:
The answer is below
Explanation:
1)
2)
3)
Because of the short, the resistance is zero.
4)
5)
6)
Answer:
Explanation:
In the development of a torsion formula for a circular shaft, the following assumptions are made: Material of the shaft is homogeneous throughout the length of the shaft. Shaft is straight and of uniform circular cross section over its length. Torsion is constant along the length of the shaft.
