Answer:
potassium, phosphorus and zinc.
Explanation:
Answer:
D
Explanation:
Facilitated diffusion is a form of passive transport hence no energy is required by the cell. This means that while the molecules are moving down a concentration gradient – line normal diffusion – the movement of the molecules needs to be facilitated (in this case by a transmembrane protein) either because the molecule is polar and can't pass through the hydrophobic region of the cell membrane, or the molecule is too big to passively pass through the small natural pores of the cell membrane.
GAU to GAC is least likely to change phenotype of an organism.
<h3><u>Explanation</u>:</h3>
Phenotype of an organism is defined as the physical characteristics of an organism. This phenotype is dependent on the genotype of the organisms. This means the phenotypic characters are actually the expressions of the genes of the organisms. Now the genes are expressed in form of codons that are the three nitrogen base sequences. Each codon codes for a particular amino acid which in turn polymerises to from the protein which actually forms the phenotype of the organism.
Now there are 20 amino acids and 64 codons. Thus there are more than 1 codons for a single amino acid. So, if a codon is replaced by another codon which codes for same amino acid, then the phenotype is least likely to be affected.
Both the GAU and GAC codes for aspartic acid. So the phenotype won't be affected much by this mutation
The following are some common procedures that we should take action of when using a bunsen burner to ensure our safety:
1. Wear safety goggles. Tie up long hair and school ties if needed. This can lower the risk of catching on fire. Put a heatproof mat underneath the Bunsen burner, put a tripod and the beaker of water for heating on top of the burner.
2. Close the air hole. Before we start up the burner, the air hole must be closed or green flame (striking back) may occur
3. light up a match or a lighter. Put it over the chimney.
4. Turn on the gas tap, you should be able to see a yellow flame now. Remove the lighter or match and open the air hole. We should have a blue flame by now.
5. the water should start to heat up. Never touch the hot beaker with bare hands.
6. When the water is heated up to the temperature they wanted to, it's time to close the air hole and turn off the gas tap.
7. If they need to move the hot beaker, use heat protection gloves
These should be the correct procedures that they should follow in order to heat the water safely.
Hope it helps!
